Camera System Adjustments; Data Setting During Camera System Adjustments - Sony MVC-CD250 Service Manual

MVC-CD250/CD400
1-4.

CAMERA SYSTEM ADJUSTMENTS

Before perform the camera system adjustments, check that the
specified values of "VIDEO SYSTEM ADJUSTMENTS" are sat-
isfied.
Note: For "CAMERA SYSTEM ADJUSTMENTS", perform in
order of item numbers.

Data Setting During Camera System Adjustments

Perform the following data setting before the camera system ad-
justments.
It is not necessary to perform the following data setting everytime
when you perform some items of camera system adjustments con-
tinuously unless the power is turned off. Only when the power is
turned off during this adjustments, perform the data setting again,
then continue the adjustments.
Set up setting:
1) VIDEO OUT of SET UP setting............... NTSC (NTSC mode)
(This adjustment must be performed in NTSC mode, so don't
set the SET UP setting to "PAL")
Data setting method:
Order Page Address Data
1 0 01
2 A 01
3 2 10
4 A 00
5 A 02
6 D 21
7 6 C1
8 6 6C
9
10 E 96
Note 1: For the bit values, refer to "5-2. SERVICE MODE",
"2-3. 2. Bit value discrimination".
Note 2: In case of wrong data.
• Select page: 2, address: 00 and set data: 29.
• Select page: 2, address: 01 and set data: 29.
• Select page: 2, address: 0C, set the bit value of bit 1 is
1.
• Select page: 2, address: 04 and set data: 04.
Set the adjusting remote commander to normal LANC,
and the power will be turned off and on automatically.
Note 3: Repeat the "Data setting method", if the power was turned
off and on during the "CAMERA SYSTEM ADJUST-
MENTS".
Procedure
01
Set the bit value of bit 5 is
"1", and press PAUSE
button. (Note 1)
Check the bit values of bit3,
bit4 and bit5 are "1".
(Note 1, 2)
Set the bit value of bit 1 is
"1", and press PAUSE
button. (Note 1)
Set the bit value of bit 1 is
"1", and press PAUSE
button. (Note 1)
07 Press PAUSE button.
Check the data changes to
"02".
01
Wait for 1 second.
00 Press PAUSE button.
After completing the camera system adjustments,
release the data setting:
Order Page Address Data
1 E 96
2 6 6C
3 D 21
4 A 02
5 A 00
6 A 01
7 0 01
5-14
Procedure
40 Press PAUSE button.
00
00 Press PAUSE button.
Set the bit value of bit 1 is
"0", and press PAUSE
button. (Note 1)
Set the bit value of bit 1 is
"0", and press PAUSE
button. (Note 1)
Set the bit value of bit 5 is
"0", and press PAUSE
button. (Note 1)
00