Filling In The Salt - Bosch Dishwasher Instructions For Use Manual

en

Filling in the Salt

Open the screw-type cap of the
compartment
24
Warning
Before switching on the appliance for
the first time, pour approx. 1 litre of water
into the salt dispenser.
Then refill with salt (not cooking salt)
until the salt container is full
(max. 1.5 kg). When you refill the salt,
water is being displaced and drains off.
Refill with salt always just before switching
on the appliance in order to prevent
corrosion. As a result, any salt solution
which has run over will be immediately
diluted and flushed out.
Then clean the filling area of salt
residues and screw the compartment
lid back on without tilting the lid.
8
.
The LOW SALT indicator
panel will light up initially but will extinguish
again after a short period when the salt
solution has become sufficiently
concentrated.
If the switch is set to "0", it is
not necessary to add any salt,
as none is consumed while the
dishwasher is operating. If the
switch is set between "1" and
"3", then salt must be added.
Do not pour detergent into the
container for special salt. This
would destroy the water
softener.
LOW SALT indicator
Salt should be added as soon as the LOW
SALT indicator
6
illuminates. For models that do not have
an indicator in the fascia panel, salt should
be added as soon as the coloured dot in
the lid on the salt container
longer visible.
Depending on the washing frequency and
the hardness setting, the regeneration salt
may not have to be topped up for several
months.
on the front
6
in the fascia panel
is no
24