Saving A Scenario To A Pc; Figure 3-18: Scenario File Page - AudioCodes Mediant 2000 User Manual

•
Edit the Step Name:
a.
b.
c.
•
Edit the Scenario Name:
a.
b.
•
Remove a Step:
a.
b.
c.
5. After clicking
6. Click Save & Finish; a message box appears informing you that the Scenario has
been successfully modified. The Scenario mode is exited and the menus of the
Configuration tab appear in the Navigation tree.
3.1.8.4

Saving a Scenario to a PC

You can save a Scenario to a PC (as a dat file). This is especially useful when requiring
more than one Scenario to represent different environment setups (e.g., where one
includes PBX interoperability and another not). Once you create a Scenario and save it to
your PC, you can then keep on saving modifications to it under different Scenario file
names. When you require a specific network environment setup, you can simply load the
suitable Scenario file from your PC (refer to ''Loading a Scenario to the Device'' on page
43).

To save a Scenario to a PC:
1. On the Navigation bar, click the Scenarios
tree.
2. Click the
the 'Scenario File' page appears, as shown below:
SIP User's Manual
In the Navigation tree, select the required Step.
In the 'Step Name' field, modify the Step name.
In the page, click Next .
In the 'Scenario Name' field, edit the Scenario name.
In the displayed page, click Next
In the Navigation tree, select the required Step; the corresponding page
opens in the Work pane.
In the page, clear all the check boxes corresponding to the parameters.
Click Next .
Next, a message box appears notifying you of the change. Click OK
Get/Send Scenario File

Figure 3-18: Scenario File Page

.
tab; the Scenario appears in the Navigation
button (located at the bottom of the Navigation tree);
42
Mediant 2000
.
Document #: LTRT-68809