Alternative Routing Parameters; Table 6-50: Alternative Routing Parameters - AudioCodes Mediant 2000 User Manual

SIP User's Manual

6.15.2 Alternative Routing Parameters

The alternative routing parameters are described in the table below.
Parameter
Web/EMS: Redundant Routing
Mode
[RedundantRoutingMode]
Web: Enable Alt Routing Tel to IP
EMS: Enable Alternative Routing
[AltRoutingTel2IPEnable]
Web: Alt Routing Tel to IP Mode
EMS: Alternative Routing Mode
[AltRoutingTel2IPMode]
Version 5.8

Table 6-50: Alternative Routing Parameters

Determines the type of redundant routing mechanism to
implement when a call can't be completed using the main
route.

[0] Disable = No redundant routing is used. If the call can't
be completed using the main route (using the active Proxy
or the first matching rule in the Routing table), the call is
disconnected.

[1] Routing Table = Internal routing table is used to locate a
redundant route (default).

[2] Proxy = Proxy list is used to locate a redundant route.
Note: To implement the Redundant Routing Mode, you first
need to configure the parameter AltRouteCauseTEL2IP
(Reasons for Alternative Routing table).
Enables the Alternative Routing feature for Tel-to-IP calls.

[0] Disable = Disables the Alternative Routing feature
(default).

[1] Enable = Enables the Alternative Routing feature.

[2] Status Only = The Alternative Routing feature is
disabled, but read-only information on the Quality of Service
of the destination IP addresses is provided.
For information on the Alternative Routing feature, refer to
'' Configuring Alternative Routing (Based on Connectivity and
QoS)'' on page
Determines the event(s) reason for triggering Alternative
Routing.

[0] None = Alternative routing is not used.

[1] Connectivity = Alternative routing is performed if ping to
initial destination fails.

[2] QoS = Alternative routing is performed if poor QoS is
detected.

[3] Both = Alternative routing is performed if either ping to
initial destination fails, poor Quality of Service is detected,
or DNS host name is not resolved (default).
Notes:

QoS is quantified according to delay and packet loss
calculated according to previous calls. QoS statistics are
reset if no new data is received within two minutes. For
information on the Alternative Routing feature, refer to
'' Configuring Alternative Routing (Based on Connectivity
and QoS)''

To receive quality information (displayed in the 'Quality
Status' and 'Quality Info.' fields in ''Viewing IP Connectivity''
on page
355
6. Configuration Parameters Reference
Description
424 .
on page 424 .
193 ) per destination, this parameter must be set to
October 2009