SIP User's Manual
Parameter
Web: Default Cause Mapping From
ISDN to SIP
[DefaultCauseMapISDN2IP]
Web: Release Cause Mapping Table
EMS: ISDN to SIP Cause Mapping
[CauseMapISDN2SIP]
Web: Release Cause Mapping Table
EMS: SIP to ISDN Cause Mapping
[CauseMapSIP2ISDN]
Version 5.8
To determine the method for setting Out-Of-Service state
per trunk, use the parameter
DigitalOOSBehaviorForTrunk_ID.
Defines a single default ISDN release cause that is used (in
ISDN-to-IP calls) instead of all received release causes,
except when the following Q.931 cause values are received:
Normal Call Clearing (16), User Busy (17), No User
Responding (18), or No Answer from User (19).
The range is any valid Q.931 release cause (0 to 127). The
default value is 0 (i.e., not configured - static mapping is
used).
This
ini
file table parameter maps ISDN Q.850 Release
Causes to SIP Responses.
The format of this parameter is as follows:
[CauseMapISDN2SIP]
FORMAT CauseMapISDN2SIP_
CauseMapISDN2SIP_IsdnReleaseCause,
CauseMapISDN2SIP_SipResponse
[\CauseMapISDN2SIP]
Where,
IsdnReleaseCause = Q.850 Release Cause
SipResponse = SIP Response
For example:
CauseMapISDN2SIP 0 = 50,480;
CauseMapISDN2SIP 0 = 6,406;
When a Release Cause is received (from the PSTN side), the
device searches this mapping table for a match. If the Q.850
Release Cause is found, the SIP response assigned to it is
sent to the IP side. If no match is found, the default static
mapping is used.
Notes:
This parameter can appear up to 12 times.
For an explanation on ini file table parameters, refer to
''Format of ini File Table Parameters''
This
ini
file table parameter maps SIP Responses to Q.850
Release Causes. The format of this parameter is as follows:
[CauseMapSIP2ISDN]
FORMAT CauseMapSIP2ISDN_
CauseMapSIP2ISDN_SipResponse,
CauseMapSIP2ISDN_IsdnReleaseCause
[\CauseMapSIP2ISDN]
Where,
SipResponse = SIP Response
IsdnReleaseCause = Q.850 Release Cause
329
6. Configuration Parameters Reference
Description
Index =
;
on page
Index =
;
199
.
October 2009