SIP User's Manual
6.8.2
Call Waiting Parameters
The call waiting parameters are described in the table below.
Parameter
Web/EMS: Enable Call
Waiting
[EnableCallWaiting]
EMS: Send 180 For Call
Waiting
[Send180ForCallWaiting]
6.8.3
Call Forwarding Parameters
The call forwarding parameters are described in the table below.
Parameter
Web: Enable Call
Forward
[EnableForward]
Version 5.8
Table 6-34: Call Waiting Parameters
Determines whether Call Waiting is enabled.
[0]
Disable = Disable the Call Waiting service.
[1] Enable = Enable the Call Waiting service (default).
If enabled, when the device initiates a Tel-to-IP call to a destination that
is busy, it plays a Call Waiting Ringback tone to the caller.
Notes:
The device's Call Progress Tones (CPT) file must include a Call
Waiting Ringback tone.
The EnableHold parameter must be enabled on the called side.
For information on the Call Waiting feature, refer to Call Waiting.
For information on the Call Progress Tones file, refer to Configuring
the Call Progress Tones File.
Determines the SIP response code for indicating call waiting.
[0]
= Use 182 Queued response to indicate call waiting (default).
[1] = Use 180 Ringing response to indicate call waiting.
Table 6-35: Call Forwarding Parameters
Determines whether Call Forward is enabled.
[0]
Disable = Disable the Call Forward service.
[1] Enable = Enable Call Forward service(default).
The device doesn't initiate call forward, it can only respond to call forward
requests.
Note: To use this service, the devices at both ends must support this
option.
299
6. Configuration Parameters Reference
Description
Description
October 2009