Voice Mail Parameters; Table 6-32: Voice Mail Parameters - AudioCodes Mediant 2000 User Manual

SIP User's Manual
Parameter
6.7.4

Voice Mail Parameters

The voice mail parameters are described in the table below. For detailed information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Parameter
Web/EMS: Voice Mail Interface
[VoiceMailInterface]
SMDI Parameters
Web/EMS: Enable SMDI
[SMDI]
Version 5.8

For a description of using ini file table parameters, refer to ''Format of
ini File Table Parameters''

Table 6-32: Voice Mail Parameters

Enables the device's Voice Mail application and
determines the communication method used between the
PBX and the device.

[0] None (default)

[1] DTMF

[2] SMDI

[3] QSIG

[4] SETUP Only (ISDN)

[5] MATRA/AASTRA QSIG
Notes:

To enable voice mail per Trunk Group, you can use a
Tel Profile ID that is configured with voice mail
interface enabled. This eliminates the phenomenon of
call delay on Trunks
voice mail is enabled using this global parameter.

For detailed information on voice mail configuration,
refer to the
Enables Simplified Message Desk Interface (SMDI)
interface on the device.

[0] Disable = Normal serial (default).

[1] Enable (Bellcore)

[2] Ericsson MD-110

[3] NEC (ICS)
Notes:

For this parameter to take effect, a device reset is
required.

When the RS-232 connection is used for SMDI
messages (Serial SMDI), it cannot be used for other
applications, for example, to access the Command
Line Interface (CLI).
295
6. Configuration Parameters Reference
Description
on page 199 .
Description
not implementing voice mail when
CPE Voice Mail Configuration Guide.
October 2009