Setting amount of rinse-aid
The amount of rinse-aid dispensed can be
Do not change the amount of rinse-aid
unless streaks (select lower setting) or
water stains (select higher setting) are left
on the utensils.
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
the digital display is indicated
Release both buttons.
Press programme button A until the
factory set value
the digital display
To change the setting,
press programme button C .
Each time the button is pressed, the set
value increases by one level; when the
has been reached, the
display jumps back to
Press START button
The set value is saved.
Close the door.
Switching off rinse-aid refill
If the rinse-aid refill indicator
impaired (e.g. when using combined
detergents containing rinse-aid
component), it can be switched off.
Proceed as described under "Setting
amount of rinse-aid" and set the value
The rinse-aid refill indicator
. The factory setting
is indicated on
Cutlery and utensils made of wood.
Delicate decorative glasses, craft and
antique utensils. These decors are not
Plastic parts not resistant to heat.
Copper and tin utensils.
Utensils which are soiled with ash, wax,
lubricating grease or ink.
Aluminium and silver parts have
a tendency to discolour and fade during
the wash cycle. Even some types of glass
(e.g. crystal glass objects) may turn cloudy
after many wash cycles.
Glass and utensil damage
Glass type and glass production
Chemical composition of the detergent.
Water temperature of the wash
Use only glasses and porcelain which
the manufacturer designates as
Use a detergent which protects
Take glass and cutlery out of the
dishwasher as soon as possible
after the programme ends.