Download Print this page

Washing The Dishes; Aqua Sensor; Switching On The Appliance; Remaining Running Time Display - Siemens Dishwasher Instructions For Use Manual

Dishwasher
Hide thumbs

Advertisement

aus

Washing the dishes

Aqua sensor *

* depending on model
The Aqua sensor is an optical measuring
device (light barrier) which measures the
turbidity of the rinsing water.
The Aqua sensor is used according to the
programme. If the Aqua sensor is active,
"clean" rinsing water can be transferred to
the next rinse bath and water consumption
can be reduced by 3–6 litres. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In the
automatic programmes the temperature
and running time can also be adjusted
to the degree of soiling.

Switching on the appliance

Turn on the tap fully.
Open the door.
Switch on ON/OFF switch
The display of the last selected
programme flashes. This programme
remains selected if no other programme
button
is pressed.
2
The expected programme duration
flashes on the digital display
Press the START button
Close the door.
The programme starts running.

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
14

Display window

Apart from information on the programme
sequence, the display window
indicates additional information on
e.g. glass protection system is active.
If you would no longer like to have this
additional information displayed, proceed
as follows.
To change the setting,
.
1

Timer programming

.
3
You can delay the start of the programme
.
9
in 1-hour steps up to 24 hours.
.
3
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
the digital display
Release both buttons.
Press programme button A until the
factory set value
the digital display
3
By pressing the C button, you can
switch the onboard computer
(additional programme information)
off
or on
.
Press START button
The set value is saved.
Close the door.
Open the door.
Switch on ON/OFF switch
Press
+ button until the timer
7
programming display
Press
+ or – button until the
7
displayed time corresponds with your
requirements.
Press START button
programming is activated.
To delete timer programming, press
the
+ or – button until
7
is indicated on the digital display
You can change your programme
selection at any time until the
programme starts.
Close the door.
also
11
.
1
until on
9
is indicated.
is indicated on
.
.
9
.
1
jumps to
.
6
, timer
9
.
6

Hide quick links:

Advertisement

loading