Dell PowerEdge M620 Owner's Manual page 122

Hide thumbs Also See for PowerEdge M620:
Table of Contents

Advertisement

Error Code
Message Information
Action
SEL0006
Message
Details
Action
SEL0008
Message
Details
Action
SEL0010
Message
Details
Action
SEL0012
Message
Details
Action
SEL1204
Message
LCD Message
Details
Action
SEL1209
Message
Details
122
If unintended, re-enable logging.
All event logging is disabled.
This message is displayed when all event logging has been disabled
by the user.
If unintended, re-enable logging.
Log is full.
When the event log is full, additional events are not written to the log.
Older events may be overwritten and lost. This message may also
appear if the user disabled event logging.
Backup and clear log.
Log is almost full.
When the event log is full, additional events are not written to the log.
Older events may be overwritten and lost.
Backup and clear log at the next maintained time.
Could not create or initialize the system event log.
If the system event log fails to initialize, platform status and failure
events are not captured. Some management software do not report
platform exceptions.
Reboot the management controller or iDRAC. Cycle system input
power. If problem persists call support.
An unknown system hardware failure detected.
Unknown system hardware failure.
If the system event log failed to initialize platform status and failure
events are not captured. Some management software will not report
platform exceptions.
Re-configure system to minimum supported configuration. If issues
persists, contact support.
The platform event filter action failed.
System policies or permissions may prevent the action from
executing. If configured, the system does not execute the action on

Advertisement

Table of Contents
loading

Table of Contents