Table of Contents
Advertisement
a: Control Target
This parameter selects no level control, delay output control
(effect balance), or feedback amount control.
a: Polarity
b: Threshold
b: Offset
c: Attack
d: Release
The "Offset" parameter specifies the value for the "Control Tar-
get" parameter (that is set to None), expressed as the ratio rela-
tive to the parameter value (the "Wet/Dry" value with "Control
Target"=Output level, or the "Feedback" value with "Control
Target"=Feedback).
When "Polarity" is positive, the "Control Target" value is
obtained by multiplying the parameter value by the "Offset"
value (if the input level is below the threshold), or equals the
parameter value if the input level exceeds the threshold.
When "Polarity" is negative, Control Target value equals the
parameter value if the input level is below the threshold, or is
obtained by multiplying the parameter value by the "Offset"
value if the level exceeds the threshold.
The "Attack" and "Release" parameters specify attack time and
release time of delay level control.
Level
Dry
Envelope
Attack
(Ducking Delay)
Wet
Target=Output Level
Polarity= (–)
Delay Time
Wet
Target=Output Level
Polarity= (+)
Dynamic Delay
Threshold
Release
Time
61: St. AutoPanningDly
(Stereo Auto Panning Delay)
This stereo delay effect pans the delay sound left and right using
the LFO.
Stereo In - Stereo Out
Left
High Damp Low Damp
Delay
Feedback
Delay
High Damp Low Damp
Right
LFO: Tri / Sin
LFO Shape
L Delay Time
0.0...1360.0
[msec]
a
L Feedback
–100...+100
R Delay Time
0.0...1360.0
[msec]
b
R Feedback
–100...+100
High Damp [%] 0...100
c
Low Damp [%] 0...100
LFO Waveform Triangle, Sine
d
LFO Shape
–100...+100
e
Phase [degree] –180...+180
Panning Freq
f
0.02...20.00
[Hz]
MIDI Sync
Off, On
MIDI,
BPM
40.00...
300.00
g
Base Note
r...w
Times
x1...x32
Panning Depth 0...100
Src
Off...Tempo
h
Amt
–100...+100
Dry, 1:99...99:1,
Wet/Dry
Wet
i
Src
Off...Tempo
Amt
–100...+100
Effects
279
Delay
FX Amt
Pan
Depth
Pan
FX Amt
LFO Phase
Sets the delay time for the left
channel
Sets the feedback amount for the
left channel
Sets the delay time for the right
channel
Sets the feedback amount for the
right channel
Sets the damping amount in the
high range
Sets the damping amount in the low
range
Selects the LFO Waveform
Changes the curvature of the LFO
Waveform
Sets the LFO phase difference
between the left and right
Sets the panning speed
Switches between using the
frequency of the panning speed and
using the tempo and notes
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Selects the type of notes to specify
the delay time for the panning
speed
Sets the number of notes to specify
the delay time for the panning
speed
Sets the panning width
Selects the modulation source for
the panning width
Set the modulation amount of the
panning width
Balance between the wet and dry
signal
Table , "Dynamic Modulation
sources, " on page 243
Amount of modulation source
Advertisement
Table of Contents
