Installation Instructions - LG WT-R107 Service Manual

2. INSTALLATION INSTRUCTIONS

2-1. HOW TO ADJUST LEVEL
1 Installation area
Install the washer on flat and firm
surface.
If the washer is installed on an
unsuitable floor, it could make
considerable noise and vibration.
Turn the adjustable legs to set the washer
horizontal(2EA).
Improper installation of the washer may cause noise and malfunctioning.
1. The ventilating openings in the base area must not be obstructed be carpeting
2. Install the washing machine on a level and firm surface, any tilt should be less
3. Wooden floors may need reinforcing to prevent the normal vibration which
4. If the washer is installed on an inclined floor, it could make considerable
Lower
Raise
when the washing machine is installed on a carpeted floor.
than 1° .
occurs with an unbalanced load.
noises and vibration and could cause a malfunction.
2 Set rear legs
Remove the level and tilt the washer
forward (pivot on front legs) about 4 to
6 inches (10 to 15cm) and gently
lower the rear legs back onto the floor.
This action will set rear leg
adjustments to correspond to front
settings
3
Checking level
Open the lid, and check if the
washer is correctly leveled by
looking down from the top.
How to use the adjusting plates
Use the adjusting plates to level the washer
when the adjustable legs cannot cover the gap.
4