Setting The Ntp Server - Fujitsu ScanSnap N1800 Operator's Manual

4.8.4 Setting the NTP Server

Set the NTP server.
1. Select [Network Settings]
The [NTP Server] window appears.
ATTENTION
For Central Admin Console, the time synchronization is not possible.
2. Enter the NTP server IP address, host name, or FQDN.
If an NTP server is not required, leave this field blank.
3. Press the [Sync Time] button.
The result of the time synchronization for the specified NTP server is shown.
Make sure that the time synchronization has been performed correctly.
4. Press the [OK] button on the confirmation window.
5. Press the [OK] button.
The NTP server is set.
HINT
The system time is automatically synchronized every 6 hours to the specified NTP server.
After the setting is changed, the time synchronization is performed immediately.
For the Admin Tool, an adjustment that advances the system time by 20 minutes or more
results in a session timeout and causes the scanner to logout.
4.8 Configuring the Network Settings
Central Admin
Console
[Basic] [NTP Server].
115