At The End Of Pyrolytic Cleaning - Miele H6361BP Operating And Installation Instructions

Cleaning and care
The door will lock automatically.
"Start at" and the start time set will
appear in the display.
As soon as the start time is reached,
the oven heating and the cooling fan
will switch on. The duration remaining
will show in the display.

At the end of pyrolytic cleaning

When the duration remaining reaches
00:00 h, a message will appear in the
display to tell you that the door is
unlocking.
When the door lock has been released
– "Process finished" will appear in the
display,
– a buzzer will sound if the buzzer
volume has been set (see "Settings -
Buzzer tones").
^ Switch the oven off.
The visual and acoustic signals are
switched off.
,
Danger of burning
Wait until the oven has cooled down
before removing residual soiling left
in the oven compartment from
pyrolytic cleaning.
^ Wipe any residues (e.g. ash) left
behind after pyrolytic cleaning out of
the oven compartment and wipe any
residues off any pyrolytic
accessories. The amount of ash will
vary depending on how dirty the
oven was.
Most soiling can be easily removed
using a clean, damp microfibre cloth,
102
or with hot water and a little washing-
up liquid on a clean sponge.
Depending on how dirty the oven
was there may be a visible layer of
soiling across the inner glass pane
on the door. This should be removed
using the pad on the reverse of a
non-scouring washing-up sponge or
with a stainless steel spiral pad and
a little washing-up liquid.
^ Extend and retract the FlexiClip
telescopic runners several times after
pyrolytic cleaning.
Please note:
– The fibre glass seal around the front
of the oven should be handled
carefully. Do not rub and scour it.
If possible you should avoid trying to
clean it.
– After pyrolytic cleaning the FlexiClip
telescopic runners may appear
discoloured or a lighter colour in
some places. This will not affect the
functioning of the runners in any way.
– Spilt fruit juices may cause lasting
discolouration to enamelled surfaces.
This discolouration is permanent but
will not affect the efficiency of the
enamel. Do not attempt to remove
these marks.