Yamaha SWK-W10 Owner's Manual page 7

4 Connect the cables in the following order.
1 Connect the AUDIO OUTPUT (SUBWOOFER) of
this unit and the input jack of your subwoofer using a
subwoofer cable.
2 Plug the power cable of your subwoofer to the AC
OUTLET terminal of this unit.
3 Plug the power cable of this unit to an AC wall outlet.
1
A B
GROUP ID
L MONO L
R R
INPUT INPUT
3 2
Subwoofer
(with internal amplifier)
Note
• Do not plug a subwoofer which power
consumption is higher than 100 W to the AC
OUTLET terminal of this unit.
5 Turn on the subwoofer.
6 Set the volume of your subwoofer to
about half way and then set the crossover
frequency to the maximum.
VOLUME
MIN MAX
Subwoofer
To AC wall outlet
3
L / SUBWOOFER
1 2 3
R
AUDIO OUTPUT AC OUTLET
This unit
2
CROSSOVER/
HIGH CUT
MIN MAX
7 Turn on the transmitting-side product.
The LED turns to green if a wireless connection
between this unit and transmitting-side product is
established.
Status LED
LED
Red This unit is turned off because the
transmitting-side product is also
turned off. Turn on the
transmitting-side product to turn
on this unit.
Orange A wireless connection is being
established. Please wait.
Green A wireless connection is
established properly.
Note
• If your subwoofer is operable with the remote
control, set the subwoofer's power management
setting to "Always On" to make the power control
of this unit functions properly.
Status
5
En