Table of Contents
Advertisement
9. Type e:\NT4\setup.exe (where e is the letter of the CD-ROM drive) and
press Enter.
10. Click Next.
11. Click Next.
12. Click Finish.
Installing the modem in Windows 2000
To install the modem in Windows 2000, do the following:
1. Turn off the computer and all attached devices.
2. Remove the computer cover.
3. Install the modem in an available PCI slot.
Note: You might need to attach the low-profile PCI bracket that is
included with this option.
4. Replace the computer cover.
5. Turn on the computer.
6. In the Found New Hardware Wizard window, click Next.
7. Select Search for a suitable driver, and then click Next.
8. Select Specify a Location.
9. Click Next.
10. Insert the V.90 PCI Data/Fax Modem Device Drivers and User's Guide CD into
the CD-ROM drive.
11. Enter e:\Win2k\setup.exe (where e is the letter of the CD-ROM drive).
12. Click OK.
13. Click Next.
14. Click Next.
15. Click Finish.
Uninstalling the modem
This section contains instructions for uninstalling the modem. For information
on installing the modem, see "Installing the modem" on page 1-2.
Uninstalling the modem in Windows 95, Windows 98 or
Windows Me
To uninstall the modem in these operating systems, do the following:
1. Click Start, click Settings, and then click Control Panel.
2. Double-click Add/Remove Programs.
3. Select Conexant HCF V.90 56K PCI Modem.
4. Click Add/Remove.
5. In Add/Remove Program window, click OK.
6. Shut down the computer. Turn off the computer and all attached devices.
7. Remove the computer cover.
8. Remove the modem from the PCI slot.
9. Replace the computer cover.
Installation guide
1-3
Advertisement
Table of Contents
