Related Manuals for Pfaff 94
Summary of Contents for Pfaff 94
- Page 2 ——---— — —-— — — — — — —...
- Page 11 into the machine, To insert the bobbin case needle rotate the balance wheel until the latch and is at its highest point. Lift the (see place the bobbin case on center stud points ill.), making sure its slot (white arrow) against the up.
- Page 21 Trim Turn...
- Page 25 Cording Use ordinary sewing foot No. 93-838 954-00, and insert a twin needle (which can be ob tained from your Pfaff dealer). Stitch length: 1.5 to 2 Cording is made with two needle threads. When threading the needles, make sure to lead each thread between a separate pair of tension discs (see ill).
- Page 26 Hemsttchng Stitch length: 2 to 2.5 93-100179 — Use a thread which is not too heavy and matches the material being hemstitched (preferably a No. 50 embroidery thread). Insert a System 130 Zwi-Ho needle. Make sure the needle and bobbin threads are the same size.
- Page 27 The Zigzag Seam The stitch width is regulated by pushing stitch width control (18) toward the left, as may be desired. Never change the stitch width setting unless the needle is outside the fabric. The stitch length is regulated by turning stitch length control (11).
- Page 28 Overcasting Edges with Zigzag Stitches Attach ordinary sewing foot. Stitch length: 2 838 954 To overcast the edges of light and medium- weight fabrics, set the machine for its maxi mum stitch width. Soft and flimsy fabrics are best overcast with a zigzag stitch of medium width.
- Page 30 Inserting I.cice Stitch length: 1 838 954 Place the lace on the material and stitch it down with straight stitches on both sides (1). Cut the fabric open under the lace insertion (2) and iron it on both sides of the lace. Sew over the edges of the lace with short zigzag stitches of medium width (3).
- Page 31 This is (19) — — —...
- Page 32 Sewing Buttonholes Attach buttonhole foot No. 847616 to the machine. Flick the needle to its left position and put the stitch width control notch R 1 (see ill.). When using No. 50 embroidery thread, set the stitch length control so that both dots are opposite each other (see ill.).
- Page 35 inch from the fabric Baste the hem about 93-100179 edge, as illustrated (1). Then flick the needle to its right position and set the stitch lenght control at ‘4’. Reduce the needle thread tension by one grade. Fold the hem (2) and place the fabric under the sewing foot so that the folded edge is Blndstitching in line with the left groove of the foot (see...
- Page 36 838 954...
- Page 40 (1 & 2). (3).
- Page 41 To remove them, pull a narrow fabric strip between the tension discs. • The Pfaff rotary hook will not normally even if the machine should be handled improperly. If thread should happen to jam in the...
- Page 42 • • •...
- Page 43 CPFAFFD Printed in Germany No. 20835 cog!. R 1070...