Installation Of Appliances - Crystal Acoustics TR - 100 Manual

I N S T A L L A T I O N O F A P P L I A N C E S
Begin the installation of the T-100 transmitter as
per the instructions in the manual:
1. In the packing you will find a double RCA cable.
Carefully connect the RCA cable to the PRE OUT output
on your amplifier. Then carefully connect the other end
of the RCA cable to the LOW INPUT on the T-100
2. If your amplifier does not have a PRE OUT then connect the two cables for speakers
in the HI INPUT inputs of the T-100
3. Connect the power cable to the mains
4.
Activate the system with the On/Off switch of the T-100
5. The transmitter will do an automatic interference detection and within five seconds it
will transmit "clearly"
After you have finished with the installation of the T-100, you can continue with the
installation of the R-100W receivers with amplifiers
1.
Verify the Ohmic resistance at the rear panel of your
speakers. For 6 or 8 Ohm speakers place the switch
found between the inputs of the receiver amplifier to
8R. If your speakers have the indication 4 Ohms place
the switch to 4R.
2. In the packing you will find two double cables.
Carefully connect the cable from the outputs of the
R-100W to the speaker's binding posts. Do the same for
the other amplifier making sure that you're connecting
the corresponding receiver amplifier to the Right or Left Speaker.
3. Once the connections are made, plug each receiver amplifier into the mains
Λ Ε Ι Τ Ο Υ Ρ Γ Ι Α Σ Υ Σ Κ Ε Υ Η Σ
8