To Attach Stand Mixer Attachment; Before Attaching Stand Mixer Attachment; Food Grinder* Attachment; To Assemble Food Grinder Attachment - KitchenAid 5SSA Instructions And Recipes Manual

To Attach Stand Mixer Attachment

Before Attaching
Stand Mixer Attachment
1. Turn Stand Mixer speed control to
"0" (OFF).
2. Unplug mixer or disconnect power.
3. Depending on which type of hub you
have, either flip up hinged cover or
loosen the attachment knob (A) by
turning it counterclockwise and remove
attachment hub cover.
4. Insert the attachment shaft housing (B)
into the attachment hub (C) making
certain that attachment power shaft
fits into square hub socket.
5. It may be necessary to rotate the
attachment back and forth. When the

food grinder* Attachment

B

To Assemble food grinder Attachment

1. Insert the grind worm (A) into the grinder body (B).
2. Place the knife (C) over the square shank at the exposed end of the grind worm.
3. Place grinding plate (D) over the knife, matching the tabs of the plate with the
notches of the grinder body.
4. Place ring (E) on grinder body, turning by hand until secured but not tightened.
NOTE: The combination food pusher/wrench (F) is used for removal of ring (E) only.
Do not use it to tighten ring (E).
NOTE: Use Sausage Stuffer (model SSA) with Food Grinder (model FGA).
6. Tighten the attachment knob by turning
C
D
fine
A
2
attachment is in proper position, the
pin on the attachment housing will fit
into the notch on the hub rim.
it clockwise until the attachment is
completely secured to mixer.
B
Coarse
E
* Food Grinder Attachment sold separately.
C
A
f