Download  Print this page

Kenwood VR-605 Instruction Manual page 2

Audio video surround receiver
Hide thumbs

Advertisement

Before applying the power
A
Caution : Read this page carefully to ensure safe
operation.
Units are designed for operation
as follows.
U.S.A. and Canada.. .........................................
AC 120 V only
Australia
...........................................................
AC 240
V only
Europe and U.K. ...............................................
AC 230 V only
China and Russia .............................................
AC 220 V only
Other countries..
........ AC 110-120 1220-240 V switchable*
For the United Kingdom
Factory fitted moulded
mains
plug
1. The mains plug contains a fuse. For replacement, use only a 13-
Amp ASTA-approved (BS1362) fuse.
2. The fuse cover must be refitted when replacrng the fuse rn the
moulded plug.
3. Do not cut off the mains plug from this equrpment. If the plug frtted
is not surtable for the power points in your home or the cable is too
short to reach a power point, then obtain an appropriate safety
approved extension lead or adaptor, or consult your dealer.
If nonetheless the marns plug is cut off, remove the fuse and
dispose of the plug immedrately, to avord a possible shock hazard
by inadvertent connectron to the mains supply.
IMPORTANT : The wires in the mains lead are coloured in accor-
dance wrth the followrng code:
Blue
: Neutral
Brown : Love
Do not connect those leads to the earth terminal of a three-pm plug.
AC voltage selection
The AC voltage selector switch on the rear panel IS set to the voltage
that prevails in the area to which the unit is shipped.
Before
connectrng the power cord to your AC outlet, make sure that the
setting position of this swatch matches your line voltage.
If not, it
must besettoyourvoltage
inaccordance wrth thefollowrngdrrectron.
AC voltage selector switch
Move swatch lever to match
your line voltage wrth a small
screwdriver
or other pornted
tool.
El m II
4-
Note :
Our warranty does not cover damage caused by excessrve lrne
voltage due to rmproper setting of the AC voltage selector swatch.
Asan ENERGYSTAR@P~~~~~~, Kenwood
Corporation
has determined
that this
product
meets the ENERGY STAR@
guidelines
for energy
effrciency.Thrs
product can save energy. Savrng energy
reduces air pollutron and lowers utility bills
Safety
precautions
WARNING :
TOPREVENTFIREORELECTRICSHOCK,
DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS IN-
SIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
A
THE LIGHTNING FLASH WITH ARROWHEAD
SYMBOL,
WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF UNINSULATED
"DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S EN-
CLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO
CONSTITUTE A RISK OF ELECTRIC SHOCKTO PERSONS.
A
THE EXCLAMATION POINTWITHINAN
EQUILATERALTRC
ANGLE IS INTENDED TO ALERT THE USER TO THE PRES-
ENCE OF IMPORTANT OPERATING AND MAINTENANCE
(SERVICINGjINSTRUCTIONSlNTHE
LITERATUREACCOM-
PANYING THE APPLIANCE.
:or the U.S.A.
FCC WARNING
Thus equipment may generate or use radio frequency energy. Changes
or modrfications to thus equrpment may cause harmful Interference
unless the modifications
are expressly approved rn the Instruction
manual. The user could lose the authorrty to operate this equipment
If an unauthorized change or modification IS made.
NOTE:
Thus equipment has been tested and found to comply with the lrmrts
for a Class B digital devrce, pursuant to Part 15 of the FCC Rules.
These lrmrts are designed to provide reasonable protection against
harmful Interference rn a residentral rnstallatron. This equipment may
cause harmful Interference
to radio communrcations,
if it IS not
installed and used rn accordance with the rnstructrons. However,
there is no guarantee that interference wrll not occur rn a particular
installatron. If this equrpment does cause harmful interference
to
radio or televisron reception, whrch can be determined by turnrng the
equipment off and on, the user IS encouraged to try to correct the
interference by one or more of the followrng measures:
- - Reorient or relocate the recervrng antenna.
- - Increase the separatron between the equipment and recerver.
- - Connect the equipment Into an outlet on a crrcurt different from
that to whtch the recerver IS connected.
- - Consult the dealer or an experienced radio I TV technician for
help.
:or the U.S.A.
Note to CATVsystem installer:
Thus remrnder is provided to call the CATVsystem Installer's attention
to Artrcle 820-40 of the NEC that provrdes gurdelrnes for proper
groundrng and, rn particular, specrfres that the cable ground shall be
connected to the groandrng system of the burlding, as close to the
pornt of cable entry as practrcal
2 lzN

Hide quick links:

Advertisement

loading

  Also See for Kenwood VR-605

  Related Manuals for Kenwood VR-605

This manual is also suitable for:

Vr-615Krf-v5060dKrfw4060dKrfw5560dKrf-v4060dKrf-v5560d