Join Both Storage Servers To The Domain - HP StorageWorks P4000 G2 User Manual

5. To assign static IP addresses to a private connection:
a. Right-click the private connection and select Properties.
b. Clear all items on the General tab except for HP Network Configuration Utility, Internet
Protocol Version 4 (TCP/IPv4), and Internet Protocol Version 6 (TCP/IPv).
c. Select Internet Protocol Version 4 (TCP/IPv4) and then click Properties.
NOTE:
For the purposes of this document, the IPv4 Internet Protocol is the documented IP
version. If you are familiar with IPv6 and prefer to use it in your network environment,
it is also supported.
d. Select Use the following IP address and enter a static IP address and subnet mask using
configuration information assigned by your network administrator.
e. Click Advanced, select the DNS tab, and clear the Register this connection's addresses in
DNS box.
f. Click OK twice and then click OK to dismiss the Local Area Connection Properties dialog
box.
The Server 1 private static IP addresses are now set.
6. To set the Server 1 public IP addresses, do one of the following:
• If a DHCP server is available on your network, allow DHCP to automatically configure your
public-facing network connections.
• If a DHCP server is not available on your network, configure a static IP address for the public-
facing network connections as documented above using configuration information assigned
by your network administrator. For the public-facing static IP address, do not clear any items
on the General tab of the connection's Properties page.
7. Repeat the preceding steps on Server 2, setting the private and public IP addresses as needed.

Join both storage servers to the domain

1. From Server 1, open Server Manager, and click Change System Properties.
P4000 G2 Unified NAS Gateway User Guide 29