Tm Removal And Installation - Mitsubishi WS-48515 Service Manual

MODELS: WS-48515 / WS-55515 / WS-55615 / WS-55815 / WS-65515 / WS-65615 / WS-65815 / WS-73615
1. DiamondShield™ Removal Procedure
The appropriate disassembly procedure given below.
Note: Wear gloves when handling the DiamondShield™ to prevent finger prints.
1. Gently insert a small plastic card (such as a
credit card or a plastic putty knfe) between the
DiamondShield™ and one end of the clip to pry
the clip loose.
WS-48515 / WS-55515 / WS-55815 / WS-65515 / WS-65815
2. Remove both clips by pulling them toward you.
3. Carefully insert the small plastic card (or plastic
putty knife) into the gap at the side/center point
of the Shield and pull the Shield slightly away
from the unit. Place your hands at the points
shown and gently bow the Shield toward you
and remove from the unit.
2. DiamondShield™ Installation Procedure
*(See the Parts List for DiamondShield™ part numbers)
To install the DiamondShield
SERVICING THE DIAMONDSHIELD™
TM
, reverse the above Removal Procedure.
Page 22
WS-48515 (ONLY)
1. Gently insert a small plastic card (such as a credit
card or a plastic putty knfe) between the notch of
the bracket and one end of the clip to pry the clip
loose.
WS-55615 / WS-65615 / WS-73615
2. From edge of trim, pull bracket outward to
open like a hinge.
4. Reinstall the two clips