Siemens 181 Workshop Manual page 23

Parameters/address space
4.2 Parameters
Parameter Value range
Hardware
Disable
•
interrupt high
Enable
•
limit 1
3
High limit 1
3
Value
•
Hardware
Disable
•
interrupt low
Enable
•
limit 1
3
Low limit 1
3
Value
•
Hardware
Disable
•
interrupt high
Enable
•
limit 2
3
High limit 2
3
Value
•
Hardware
Disable
•
interrupt low
Enable
•
limit 2
3
Low limit 2
3
Value
•
Potential group
Use potential group of the
•
left module
Enable new potential
•
group
Diagnostics: Missing supply voltage L+: Detection per module or alarm per channel
1
Interference frequency suppression: Interfering signals at 400 Hz are automatically included in the filtering at 50 Hz.
2
Due to the limited number of parameters at a maximum of 244 bytes per ET 200SP station with a PROFIBUS GSD
3
configuration, the configuration options are restricted. If required, you can still assign these parameters using data
record 128 as described in the "GSD file PROFINET IO" column (see table above). The parameter length of the
I/O module is 24 bytes.
Only for configuration with PROFIBUS GSD file: The set reference junction is used with the additional parameter "Kx
4
Reference junction activated" in the case of "Enable". In the case of "Disable", "No reference channel mode" is used for
RTD and "Fixed reference temperature" is used for TC.
For 2-wire connection only
5
Note
Unused channels
"Deactivate" unused channels in the parameter assignment to improve the cycle time of the
module.
A deactivated channel always returns the value 7FFF
22
Default Reconfiguration
in RUN
Disable Yes
8500 Yes
Disable Yes
-2000 Yes
Disable Yes
8500 Yes
Disable Yes
-2000 Yes
Use potential No
group of the left
module
Analog input module AI 4xRTD/TC 2-/3-/4-wire HF (6ES7134-6JD00-0CA1)
Scope with configuration
software, e.g.,
STEP 7 (TIA Portal)
GSD file
PROFINET IO
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Module
.
H
Manual, 02/2014, A5E03573289-AD
GSD file
PROFIBUS DP
-
-
-
-
-
-
-
-
Module