Table of Contents
Advertisement
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully charged
and discharged.
¤
6.5
h
¤
Please note
◆
The handset is pre-registered with the base. If you have purchased a
model with multiple handsets, all handsets will already be registered
with the base. You do not need to register the handset again. The internal
handset number appears in the top left of the display, e.g. 1 (
However, if a handset is not registered with the base (Register HS or Put
into base is displayed), please register the handset manually (
◆
If you have purchased multiple devices, you can upgrade your Gigaset to
a cordless PABX by registering all A120/A220 handsets at the same base
¢
(
page 9).
◆
After the first battery charge and discharge, you may place your handset
in the charger after every call.
◆
Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
◆
The batteries may warm up during charging. This is not dangerous.
◆
After a while, the charge capacity of the batteries will decrease for techni-
cal reasons.
Charge the handset in the base for 6.5 hours.
Please note
The handset must only be placed in the desig-
nated Gigaset base or charging cradle.
After charging, remove the handset from the
base and only replace it when the batteries are
fully discharged.
¢
¢
4
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming
calls, and so that the alarm can be used.
¤ u
MENU
Settings
and year in 6-digit format)
¤
format)
OK (display message: Saved)
¤ a
(press and hold to return to idle status)
When entering the time and date, you can move the position of an entry to the left or
right by pressing the control key
Please note
If your phone receives the date and time during calling line display (e.g., via your
network provider, a router or PABXs), you can specify whether this data should be
copied to your phone:
¤
Press the key sequence: MENU
The following is displayed;
the current setting flashes:
¤
Press one of the following keys to specify, when this data should be copied to
your phone:
Q
Never
1
Once, in case the date/time is not set on your phone
or
2
page 1).
or
Always
Your selection is displayed (e.g. 2):
¤
page 9).
Press the display key OK.
Issued by
Gigaset Communications GmbH
Frankenstr. 2a
46395 Bocholt
Germany
¤
¤
¤
¤
¤
OK
Date/Time
OK
Date
~
¤
¤
¤
OK
Time
(enter hours and minutes in 4-digit
u
up or down.
¤ P#Q5#MI
973 SET: [ 0 ]
973 SET: [2]
Version: 10.05.2013
© Gigaset Communications GmbH 2013
All rights reserved. Subject to availability.
Rights of modification reserved.
www.gigaset.com
This user guide is made from 100 % recycled paper.
~
(enter the day, month
Hide quick links:
Advertisement
Table of Contents
