Motorola DCT5100 User Manual page 34

Connecting a TV, Stereo VCR, DVD, and Stereo Receiver
or Amplifier
This cable configuration can be used for a mono or stereo TV because
the TV audio and video jacks are not used.
If your TV supports multiple sets of video and audio inputs (such as
VID1, VID2, etc.) see "Connecting a DCT5100 to an A/V Receiver, TV,
and Stereo VCR". When you have completed those connections, refer to
the diagram illustrated here to connect your DVD to your TV.
1
Connect an RF coaxial cable to the cable wall outlet and the
IN
connector on the DCT5100.
2
Connect an RF coaxial cable to the
DCT5100 and the
3
Connect an RF coaxial cable to the
VCR and the
4
Connect a set of stereo audio cables between the
R L
and connectors on the DCT5100 and the
connectors on the stereo receiver or amplifier.
5
Connect a stereo audio cable from the
on the stereo receiver or amplifier and the
connector on the stereo VCR.
6
Connect a stereo audio cable to the
connectors on the stereo VCR and the
on the stereo receiver or amplifier.
7
Connect a stereo audio cable to the
the stereo receiver or amplifier and the
connectors on the DVD.
8
Connect a video cable to the
INPUT VIDEO
the
To watch TV or view VCR recordings, the TV must be tuned to the
DCT5100 and VCR output channel, typically 3 or 4. To watch a DVD, the
TV VIDEO input must be used.
The video connection method does not support high definition video. For
more information, see "Connecting Your DCT5100 to an HDTV – Video
Only" on page 16.
CABLE ANTENNA IN
/
CABLE ANTENNA IN
/
VIDEO OUT
connector on the TV.
DCT5100 User Guide
TO TV VCR
/
connector on the stereo VCR.
TO TV
connector on the stereo
connector on the TV.
AUX IN R
TAPE OUT R
INPUT AUDIO R
OUTPUT AUDIO R
TAPE
1
CD IN R
and
AUDIO OUT ANALOG R
connector on the DVD and
27
CABLE
connector on the
AUDIO OUT
L
and
L
and connectors
L
and
L
and
IN R L
and connectors
L
connectors on
and
L