Replacing The Display - Dell Inspiron 700m Service Manual

1 display cable tab
2 display module
3 speaker cable connector
4 display cable connector
NOTICE: Do not pull on the signal cable. Pull the signal connector to disconnect the cables.
12. Disconnect the signal cable from the system board.
13. If a tape secures the signal connector, remove it and disconnect the signal cable from the system board.
14. Remove the display module out of the bottom case.
Replacing the Display
1. Replace the display module into the bottom case and open the display 180 degrees.
2. Replace the two M2.5 x 6-mm screws on the back of the computer.
3. Connect the speaker cable connector.
4. Connect the display cables on the left and right sides of the unit.
5. Connect the antenna cables.
6. Carefully thread the antenna cable back into place and connect both antenna connectors, matching the color codes.