Replacing The System Board; Removing The Power Supply - Dell Dimension 5000 Service Manual

Hide thumbs Also See for Dimension 5000:
Table of Contents

Advertisement

 
3. Disconnect any telephone or telecommunication lines from the computer.
 
4. Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.
 
5. Open the computer cover.
 
6. Remove any components that restrict access to the system board (CD/DVD drive(s), floppy drive, hard drive, I/O panel).
 
7. Remove the heat sink assembly and processor.
 
8. Disconnect all cables from the system board.
 
9. Remove the 10 screws from the system board (see illustrations below for screw locations).
 
10. Slide the system board assembly toward the front of the computer, and then lift the board up and away.
1 system board
2 screw (10)
 
11. Place the system board assembly that you just removed next to the replacement system board to ensure it is identical.
 

Replacing the System Board

 
1. Gently align the board into the chassis and slide it toward the back of the computer.
 
2. Replace the screws on the system board.
 
3. Replace any components and cables that you removed from the system board.
 
4. Reconnect all cables to their connectors at the back of the computer.
 
5. Replace the
computer
cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug the cable into the computer.
 
6. Connect your computer and devices to electrical outlets, and turn them on.
 Power Supply
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
 

Removing the Power Supply

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dimension 5000

Table of Contents