Whirlpool GAS DRYER Installation Instructions Manual page 21
Gas dryer/canadian electric dryer
Hide thumbs
Also See for GAS DRYER:
- Installation instructions manual (36 pages) ,
- Installation instructions (5 pages) ,
- Use and care manual (28 pages)
Table of Contents
Advertisement
Available languages
Available languages
2.
Move the door strike
Using a TORX
T25
screwdriver, remove the 2 screws
®
®
securing the door strike to the door frame of the dryer.
Remove the 4 screws above and below the door strike and
set aside for later use. Rotate the strike 180° and attach to
the opposite side of dryer door frame, as shown.
3.
Remove inner door from
outer door
Release tab
Release tab
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, remove the 13 screws securing the
inner door to the outer door. Lift off the inner door and set
aside.
NOTE: There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar flat object between the inner
and outer doors at the locations shown to release the tab.
4.
Remove hinge and latch
from inner door
Latch
Hinge
Using a TORX
T25
screwdriver, remove the 3 TORX
screws
®
®
®
securing the latch plate and the 5 screws holding the hinge
assembly in place.
5.
Reinstall hinge and latch on
opposite sides
Latch
Latch
Using a TORX
T25
screwdriver, reinstall the latch plate and
®
®
hinge assembly on the opposite sides from which they were
removed.
Page 21
Hide quick links:
Advertisement
Table of Contents
