Table of Contents
Advertisement
Quick Start
To connect the LCD monitor to your system, follow these instructions:
NOTE:
Make sure to read "Recommended Use" (page 4) before installation.
In order to display the maximum resolution, a display controller that can output a resolution of 1200 x 1600 (in
portrait mode) or 1600 x 1200 (in landscape mode) for MD210C2/MD211C2 and 1536 x 2048 (in portrait mode) or
2048 x 1536 (in landscape mode) for MD211C3 is needed.
1. Turn off your computer.
2. For a PC with DVI digital output: Connect the DVI-D cable to the connector of the display controller in your system (Figure
A.1). Tighten all screws.
For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display controller in your system
(Figure A.2).
DVI-D cable
Figure A.1
NOTE:
1. Please use a DisplayPort cable with a DisplayPort logo.
2. When removing the DisplayPort cable, hold down the top button to release the lock.
3. Height adjustment is locked by a lock button. Place hand on top of the monitor stand to push down the screen to the lowest
position. Slide the lock button to unlock (Figure B.1).
NOTE:
Handle with care when unlocking the stand.
Place hands on each side of the monitor to tilt the LCD panel to a 30-degree tilt angle and lift up to the highest position.
Slide the cable cover up (Figure B.2).
NOTE:
The cable cover is not removable.
Figure B.1
DisplayPort cable
Cable cover
English-7
Figure A.2
30° Tilt
Figure B.2
Advertisement
Table of Contents
