Verify Each Computers Identification; Verify Network Adapter Installation - D-Link DFE-690TXD User Manual

–– without un- needed crossovers in the connector wiring). Check that the
supporting hub is powered-on and operating normally, and that the hub is
properly qualified (under 10Base-T and/or 100Base-TX standards).

Verify Each Computers Identification

If more than one computer on your network has the same "Computer name,"
communications may be negatively affected. Also, each computer must have
the same "Workgroup" name to communicate properly.

Verify Network Adapter Installation

If your Network Adapter were not installed, including the Network System
Software or Device drivers, your network will not function properly. Use these
steps to verify that your Network Adapter is properly installed.
1. Double-Click the "System" icon in the Control Panel.
2. Click the "Device Manager" tab on top of the "System Properties"
dialog box.
3. Double-Click "Network Adapters" if you do not see any items
branching out. You should see "D-Link DFE-690TXD Cardbus PC
Card" branching out after double-clicking "Network Adapters."
If you do not see any items branching out after double-clicking "Network
Adapters," your Network Adapter has not been properly installed. Start at the
beginning of the "Quick Install Guide."
If you see symbols such as yellow exclamation point or red "X" over the icon
adjacent to "D-Link DFE-690TXD Cardbus PC Card," your card is not
installed properly or may have a problem. Double-click the "D-Link DFE-
690TXD Cardbus PC Card" and read the explanation of the problem. This
information will be helpful if you require technical support from D-Link.
- 8 -