Hitachi UltraVision L42S601 Operating Manual page 5

How To Set Up Your New Hitachi
To take measures to prevent the LCD Flat Panel Television from tipping over and prevent possible injury
it is important to mount the unit in a stable and flat surface.
Securing to a Wall
1. Using metallic wire (two places) fasten the set to
the clamping screw on the rear of the LCD Flat
Panel TV as shown below.
2. Keep the LCD television 4 inches away from the
wall except when mounted using the wall mount
bracket.
3. Secure the television to the wall as shown.
A
(a) Power Swivel (b) Power Swivel
NOT USED USED
* Please adjust the wire length to avoid
touching the wall when turning the TV.
NOTES: 1. Do not block the ventilation holes of the
LCD Television. Blocking the ventilation
holes might cause fire or defect.
2. In case of an abnormal symptom, unplug
the AC cord.
3. If you purchased the wall mount bracket
option, please ask for professional installer.
Do not install by yourself.
4. Install the unit at a proper area where it does
not expose anyone to any danger of hitting
themselves (for example their hands, head
or face, etc.) against the edge of the unit and
cause personal injury.
5. If the Power Swivel feature will not be
used, the LCD television should be
secured to the wall as shown in fig. (a).
6. If the Power Swivel feature will be used,
the LCD television should be secured
to the wall as shown in fig. (b).
Caution when moving the main unit
As this product is heavy, whenever it is moved, two
people are required to transport it safely. Whenever the
unit is moved it should be lifted forward using the top
and base on both sides of the Television for stability.
When moving the Television, lift the handles , then
support the bottom frame as shown below.
47" & 42 "
ANTENNA
Unless your LCD Television is connected to a cable
TV system or to a centralized antenna system, a good
outdoor color TV antenna is recommended for best
performance.
Wire
exceptionally good signal area that is free from
interference and multiple image ghosts, an indoor
antenna may be sufficient.
LOCATION
Select an area where sunlight or bright indoor
illumination will not fall directly on the picture screen.
Also, be sure that the location selected allows a free
flow of air to and from the perforated back cover of the
set. In order to prevent an internal temperature
increase, maintain a space of 10 cm (4 inches) from the
B
sides/back of the Television, and 30 cm (12 inches)
from the top of the television to the ceiling. To avoid
cabinet warping, cabinet color changes, and increased
A B
42" 5 in. 12 in.
chance of set failure, do not place the TV where
47"
12.5 cm 30 cm
temperatures can become excessively hot, for
example, in direct sunlight or near a heating appliance,
etc.
CONNECT POWER SWIVEL CABLE
Connect one end of cable to the swivel slot of the
LCD Rear Panel. Connect the other end to swivel
slot of the Table Top Stand. For more detail information,
please refer to next page installation instruction.
TURNING ANGLE
The maximum turning angle is 30° (left and right). Do
not place any objects on the path of the monitor when
using the power swivel feature.
Television
LCD
However, if you are located in an
30 cm (12 inches)
10 cm (4 inches)
30° C
30°
D
10 cm (4 inches)
C D
9.1 in.
14.05 in.
42"
23.1 cm 35.7 cm
10.2 in.
15.15 in.
47"
25.9 cm 38.5 cm
5