Hitachi UltraVision L46S603 Operating Manual page 13

Hitachi lcd flat panel hdtv operating guide
Hide thumbs Also See for UltraVision L46S603:
Table of Contents

Advertisement

TV Setup Wizard
Your Hitachi LCD television has a TV Setup Wizard feature which has the ability to help you easily setup the first time you turn on your TV
and find the channels available in your area. Please follow the instructions below.
The First time you turn on your Hitachi LCD TV the setup wizard
screen will appear. The first step is to set the language of your TV
On Screen Menu. Select the language that you prefer. Use the
and
CURSOR to select language and press the SELECT button
on the remote control.
Setup Wizard (1/7)
Please select language ...
English
Español
Français
Cancel
Navigate
The second and third steps are to set the date and time. There are
two options; one for automatic time setting in which you will select
only the time zone in your area and the second option is a manual
setup for the date and time. Use the CURSOR pad to select and
change the options with the remote control.
Setup Wizard (2/7)
Please set time mode ...
Auto
Manual
Previous
Cancel
Navigate
Select
SEL
The fourth step is designed to find broadcasting or cable
channels. There are two options, Air for an external antenna
and Cable for a cable system provider in your home. Use the
and
CURSOR to select a source and press the SELECT
button on the remote control.
Setup Wizard (4/7)
Please select TV RF tuning band ...
Air
Cable
Previous
Navigate
SEL
Select
Setup Wizard (3/7)
Please select Time Zone ...
NST
MST
AST
PST
EST
AKST
CST
HST
Previous
Cancel
Navigate
SEL
Select
Setup Wizard (3/7)
Please enter the date and time ...
Year
2009
Month
Jan
Date
1
Time
12:00 AM
OK
Previous
Cancel
Navigate
SEL
Select
Cancel
Select
SEL
The fifth step will start the scanning feature to find the channels
available on the antenna or cable system. Press the SELECT
button on the remote control to start the channel scan.
Setup Wizard (5/7)
Please check that the RF cable is
connected properly.
Start
Previous
Navigate
The sixth step is the scanning process of the channels, it will first
the scan the analog channels and then the digital channels. The
scanning process will show how many channels have been found.
Please be patient while the scanning process searches for the
available channels in your area. If you wish to cancel the process,
press the SELECT button on the remote control.
Setup Wizard (6/7)
Searching, please wait ...
Searching Analog CH
Analog Channels Found
Digital Channels Found
10%
Cancel
SEL
Once the user cancels the wizard, the wizard will
NOTES
not be shown again.
If you see the screen above and if you did not
connect your Antenna cables to your TV, turn off
your TV, unplug the power cord and connect your
cables according to the applicable connections
in the "First Time Use" section of this Operating
Guide.
After completing the TV Setup Wizard, these
screens will not appear again. For updating and
adding the channels available in your area refer to
the Add Channels to List feature on page 40.
The last step is the completion of process, it shows a brief message
and you are ready to view TV programing. This final message will
be shown for a few seconds and then the first detected channel will
be tuned in. You may also press EXIT on the remote control to tune
to the first detected channel.
Setup Wizard (7/7)
Congratulations. TV setup is done.
EXIT
Cancel
Select
SEL
Channel 3
10
15
Cancel
Exit
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

L55s603 - lcd direct view tvUltravision l55s603

Table of Contents