Download  Print this page

Hitachi L32A104 Owner's Manual page 15

Hitachi flat panel television user manual
Hide thumbs

Advertisement

Table of Contents
Connections to other equipment
Using an AV Amplifier with built-in digital surround
If you are using an AV amplifier with built-in digital surround sound, you can enjoy various audio systems including Dolby Digital Surround
audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, etc. as shown below.
Rear of the unit
To DIGITAL AUDIO
COAXIAL OUT
Coaxial digital cable
(not supplied)
To Coaxial
Digital Audio IN
AV Amplifier with built-in digital surround
decoder as listed above
NOTE:
When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio. There will be no sound
output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.
To connect the TV to a PC (Personal Computer)
Before you connect this TV to your PC, change the adjustment of your PC's Resolution and Refresh rate (60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA connector PC MONITOR IN on
the rear of the TV. Attach the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio cord to
the audio output of your Multimedia computer and to the AUDIO connector of the PC/DVI AUDIO IN jack of the TV. You can also connect
the PC with HDMI cable. If you use HDMI cable, you don't have to connect the audio cord. If you use a DVI-to-HDMI cable, please
connect an audio cord in the same way as VGA cable.
Press INPUT on the remote control to select PC mode.
Switch on the computer. The TV can operate as the computer monitor.
Rear of the unit
To PC
MONITOR
IN
To PC/DVI
AUDIO IN
VGA cable (not supplied)
Audio cord (not supplied)
To HDMI1/DVI
HDMI cable (not supplied)
NOTE:
The on-screen displays will have a different appearance in PC mode than in TV mode.
If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV-screen.
Front
Speaker
(Left)
Surround
Speaker (Left)
Monitor Display modes
MODE Resolution Refresh rate
VGA
640x480
VGA
720x400
SVGA
800x600
XGA
1024x768 60/ 70/ 75 Hz
WXGA 1280x768 60Hz
WXGA 1280x720 60Hz
WXGA 1360x768 60Hz
To return to normal mode
Press INPUT again.
Front
Speaker
Subwoofer
(Right)
TV
Center Speaker
Surround
Speaker
(Right)
60/ 72/ 75 Hz
70Hz
56/ 60/ 72/ 75 Hz
(continued)
15

Advertisement

Table of Contents
loading

  Also See for Hitachi L32A104

  Related Manuals for Hitachi L32A104