Hardware Installation - D-Link SECURICAM Network DCS-2120 User Manual
Dcs-2120 wireless network camera with 3g mobile video support
Hide thumbs
Also See for SECURICAM Network DCS-2120:
- User manual (151 pages) ,
- Quick install manual (26 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Section 1 - Product Overview
Hardware Installation
Connect an Ethernet cable to the Ethernet connector located on the Network
camera's bottom panel and attach it to the network.
Note: It is required that an Ethernet cable is used during initial setup. Once your
wireless configuration is set, you may disconnect the Ethernet cable.
Attach the external power supply to the DC power input connector located on the
Network camera's bottom panel (labeled 5VDC) and connect it to your wall outlet.
When you have a proper connection, the LED will light up.
The LED will flash red and blue when you first power on the unit. The LED will not
turn blue until the camera has received a network IP address.
D-Link DCS-10 User Manual
Advertisement
Table of Contents
