Hitachi 42HDT79 Operating Manual page 72

Setup
5. Use the CURSOR PAD
"Other" from brand name choices.
6. Use the CURSOR PAD
"Learning Mode" then press the SELECT
button.
AV Net Setup Wizard : A/V Receiver Setup
Please choose the Brand Name of your
A/V Receiver. If you can not find the
Brand Name, please choose "Other" and
proceed to the Learning mode by pushing
the Learning Mode Button.
Brand Name Other
Move Change Brand Name
7. Use the CURSOR PAD
select the Soft Key to learn (Ex. VOL
press the SELECT button.
AV Net Setup Wizard : Custom Settings
Select the A/V Receiver softkey to learn?
TV Softkeys
POWER CH
MUTE CH
SOURCE 1 SOURCE 2
SOURCE 6 SOURCE 7
Move SEL Select
8. Press and hold the VOL
Receiver remote control while pointing directly
at the learning AV NET sensor of the Plasma
TV (located at the lower right corner of the
screen) at a distance of 3.2 feet or 1 meter
maximum.
AV Net Setup Wizard : A/V Receiver Setup
Press and hold desired button to transfer the
command to AV NET.
VOL
Please wait while AV NET
Learns the command....
Move SEL Select
9. If the IR code transfer was not completed, the
screen below appears. Repeat step 8 to try
again.
AV Net Setup Wizard : A/V Receiver Setup
VOL
Transfer not completed!
Try again?
Move Select
SEL
72
or to select
or to highlight
Learning Mode
Back Next
, , and to
), then
VOL
VOL AUDIO
SOURCE 3 SOURCE 4 SOURCE 5
SOURCE 8 SOURCE 9 SOURCE 10
Back Done
button of your A/V
Cancel OK
10. If the IR code transfer was successful, the
screen below appears, then select "OK" to
continue setup.
AV Net Setup Wizard : A/V Receiver Setup
VOL
Transfer was successful.
Press OK to store and continue.
Move Select
SEL
11. Select another Soft Key to learn or select
DONE to move on to the next screen.
AV Net Setup Wizard : Custom Settings
Select the A/V Receiver softkey to learn?
TV Softkeys
POWER CH VOL
MUTE CH VOL
SOURCE 1 SOURCE 2 SOURCE 3
SOURCE 6 SOURCE 7 SOURCE 8
Move SEL Select
12. Select the Test button VOL
response of the device to this command.
13. Use the CURSOR PAD
highlight NEXT, then press the SELECT button
to move on to the next SETUP screen.
AV Net Setup Wizard : A/V Receiver Setup
Select the Test button. If device
responds to this command, proceed to
"Next". Otherwise, try another IR
Code Set number.
Brand Name Other
IR Code Set Other
Learning Mode
Test Button POWER SOURCE 1
Move IR Out
SEL
14. Use the CURSOR PAD
Input that connects to the video and audio
output of the A/V Receiver.
15. Use the CURSOR PAD
highlight NEXT, then press the SELECT button
to move on to the next SETUP screen.
AV Net Setup Wizard : A/V Receiver Setup
Brand Name Other
IR Code Set Other
TV Input Settings
If you connect the video or audio
output of the A/V Receiver to this TV,
please select a TV Input.
TV Input Not Connected
Move Change Input
SEL
Cancel OK
AUDIO
SOURCE 4 SOURCE 5
SOURCE 9 SOURCE 10
Back Done
to check the
, , and to
VOL
Back Next
or to select the TV
, , and to
Back Next
Select