Gas Burners; Lighting And Adjusting - Miele KM 326G Operating Instructions Manual

Gas burners

If a burner blows out, the electronic ignition
automatically sparks all burners to relight the
flame.
The flame is lit by means of an electrical ignition
device. When the burner control is pressed and
turned, a high voltage flows into the electrode
by the burner. Sparks are created. A spark
ignites the gas to give a flame.

Lighting and adjusting

HI
high-speed and super high-speed burners
A symbol above the control knob indicates
which burner is being operated.
– Push in the burner control knob and turn it to
the "HI" position. Ignition follows.
– Turn the control to the desired setting once
the burner is alight. The LED's indicate the
position of the control knob.
You may set the knob at any position between
"HI" and "LO".
OFF
LO
HI
2-zone super high-speed wok burner
Outer ring
– Push in the burner control knob and turn it to
the "HI" position. Ignition follows.
– Turn the control to the desired setting once
the burner is alight.
You may set the knob at any position between
"HI" and "LO".
Inner ring
– Push in the burner control knob and turn it to
the "HI" position. Ignition follows.
– Turn the control to "LO" once the burner is
alight.
– Push in the burner control knob and turn it to
any position between "LO" and "XLO".
OFF
XLO
LO
5