Installing Appliance - Miele KM 326G Operating Instructions Manual

Installing appliance

1. Install the appliance according to the
installation instructions.
2. Attach the moulding at the rear to the
undertray. Put the hob back in the work
surface and fasten the bracket clamps
underneath the work surface.
3. Set the gas pressure regulator to a new
pressure of 10" WC (4" WC, natural gas).
Check pressure (see page 21). Permitted
pressures: minimum 11" WC (5" WC, natural
gas), max. 1/2 psi.
4. Reconnect gas supply, reconnect the manifold
pipe, reconnect the electrical power.
5. Put the burner heads and pan supports in
place. Make sure the burner heads are
mounted the right way. Put the burner head
marked "A" on top of the wok burner.
(Natural gas)
Propane gas
Propane gas
(Natural gas)
(034)
007
054 025 036 040 036
(100) (042) (055) (060) (055) (060)
Testing converted appliance
Note
This appliance has been internally tested for gas
leakages by the manufacturer.
Caution
Check converted hob for gas leaks. Check the
connection with a soapy solution. Never use a
flame of any sort.
Check that the hob functions normally:
Turn on the gas supply and plug in the power
supply cord.
Light each of the burners individually.
When the burner is at low setting, or when the
control knob is turned quickly from 'high' to 'low',
the flame should not go out.
When set at 'high', the gas flame must burn with
the center clearly visible.
Locations of injectors and minimum
adjustment screws
(166)
(170)
090 087
040 075
(145)
(145)
075
087
(166)
25