Table of Contents
Advertisement
1. First loosen the 8 mm ring securing the gas
feed pipe. Disconnect the gas pipe. The
actual injector is a thin metal cap mounted
between the two brass fittings attached to
the left of the wok burner body.
gaspipe
injector
2. Two 12 mm wrenches are needed to
separate the fittings.
Use one 12 mm wrench to keep the right-
hand fitting in place, while using the other
12 mm wrench to loosen the left-hand fitting.
3. With the left fitting loosened, unscrew the
right-hand fitting from the wok burner body.
4. Holding them vertical, take both fittings
apart. The metal cap with the injector will
remain on top of the lower fitting. Replace
the injector cap with the injector cap marked
007 (034, natural gas) and put the two fittings
back together.
Warning
Make sure that the natural gas injector is
removed from the fitting when the propane gas
injector is installed.
5. Screw the assembled fittings back into the
wok burner body. Carefully tighten both
fittings. Do not overtighten.
6. Reattach the gas pipe and tighten the 8 mm
Note
Adjust the air slot on the inner ring injector now.
Inner ring injector
The slot is adjusted by shifting the metal clip
around the right-hand fitting. Move the clip to
obtain a full opening of the hole (A) in the fitting.
Reference table
LP gas
high-speed burner
super high-speed burner
wok burner inner ring
wok burner outer ring
natural gas
high-speed burner
super high-speed burner
wok burner inner ring
wok burner outer ring
ring.
A
Inner ring air slot (A)
adjustment
injector
screw
0.75 mm
0.36 mm
0.03"
0.014"
0.87 mm
0.40 mm
0.034"
0.016"
0.50 mm
0.25 mm
0.02"
0.01"
0.90 mm
0.54 mm
0.035"
0.021"
adjustment
injector
screw
1.45 mm
0.55 mm
1.66 mm
0.60 mm
0.60 mm
0.42 mm
1.70 mm
1.00 mm
B
23
Hide quick links:
Advertisement
Table of Contents
