Table of Contents
Advertisement
Tr o u b l e s h o o t i n g
15
No AC output voltage. Red Fault LED light is illuminated.
Possible Cause:
- Inverter may be overloaded.
Solution:
- Disconnect all appliances connected to the inverter and reset the inverter by
turning the ON/Off switch to Off then back to ON.
Possible Cause:
- Battery voltage may be too high.
Solution:
-The inverter will restart if the battery voltage drops below 15.5 volts DC.
Possible Cause:
- Battery voltage may be too low.
Solution:
- Battery voltage becoming low, recharge battery and resume inverting power.
Possible Cause:
- Over temperature.
Solution:
- Allow the inverter to cool down. The inverter will start automatically.
Possible Cause:
- Unit may be defective
Solution:
- Call Factory Service 800 number.
No AC output voltage. NO Lights are illuminated.
Possible Cause:
- Battery voltage is too low.
Solution:
- Recharge the batteries. Restart the inverter with recharged batteries.
Possible Cause:
- Poor DC wiring.
Solution:
- Turn the inverter to Off. Disconnect the DC wiring. Use proper wiring and ensure
all connections are secure.
TruePower Overview
5
Power Fault
GFCI 110 VAC Output
Remote Port
4
5
On Board
Deluxe Inverter Remote
Solutions
Power Fault
A ProMariner Company
DC
Inverter
Input Voltage
Output Current
100
%
100
%
GFCI 110 VAC Output
On
4
Off
0
0
Power
Over Load
Over Temp
The above picture outlines the front of the TruePower Inverter with bullets pointing out digital
bar graph display, on/off switch, led locations etc. Please Reference Table below for features:
1. ON/Off Switch turns the inverter to ON, OFF
2. Power light illuminates when inverter is on.
3. Fault Light illuminates Red for fault conditions such as over temperature, output
overload, or battery low voltage.
4. Two GFCI Protected AC Outputs to power connected appliances, Reset and Test
monthly capabilities.
5. Ventilation Openings provide air circulation for peak performance.
(front and rear panel)
6. Remote Port for optional simple remote with on / off switch and power and fault led
7. Main Breaker
8. Outlet Breaker
9. Terminal Strip
10
DC Input
10V-15VDC
TruePower1500
15
Up to 150Amps Continuous
P/N: 05150
AC Output
110V - 120VAC 60Hz
1500 Watts Continuous
12.5 Amps Continuous
3000 Watts Peak
POS
12
NEG
13
11
The picture outlines the back of the TruePower
Inverter with bullets pointing out DC connections,
fuse holder locations etc. The Table below references
the above numbered features of the back panel
10. DC Input Cable (Positive +)
11. DC Input Cable (Negative -)
12. Fan Housings
O v e r v i e w
2
3
On Board
Solutions
A ProMariner Company
Power
On
6
Over Load
Off
Over Temp
2
GFCI PROTECTED 110 VAC Output
3
1
POS
14
NEG
DC Input
10V-15VDC
TruePower 2000 (12V)
Up to 200Amps Continuous
P/N: 05200
AC Output
110V - 120VAC 60Hz
2000 Watts Continuous
Up to 18.2 Amps Continuous
4000 Watts Peak
13. Ground Stud
14. Mounting flanges (Side)
15. Tech Spec Label
4
5
7
1
9
4
8
13
12
11
10
15
14
Advertisement
Table of Contents
