Note:
• If the cover of disc insertion btock is open, the
ACCESS/PC
indicator will blink when an image is
displayed on the LCD monitor screen: In this case,
the DVD video camera/recorder
will not turn off even if
the power switch is set to "OFF"
If the cover remains open after a while, the DVD video
camera/recorder
will automatically
turn off.
• Disc cannot be inserted or removed unless a charged
battery or AC adapter/charger
is connected
to the
DVD video camera/recorder.
• If a discharged
battery is used, the disc cannot be
inserted or removed: Connect a charged battery or
AC adapter/charger
to the DVD video camera/
recorder
• If there is some delay before recording starts, refer to
"Check 4" on page 158.
• If the disc is not correctly
attached to the turntaNe,
it
witl be difficult to close the cover: if this happens,
do
not forcibly close the cover (this could cause a fault),
but re-attach the disc to the turntable
correctly
• If a single-sided
disc is inserted
into DVD video
camera/recorder
with the printed label facing the
inside, an error message
will appear
Remove the
disc and reinsert it with its recording side facing the
inside
See "Trouble Messages" on page 160.
• When using double-sided
disc
Recording
is possible on both sides of double-sided
disc However, when recording or playback on one
side is finished, recording or playback will not move
automatically
to the other side. Remove the disc once
from the DVD video camera/recorder,
turn over the
disc and insert it again for continued use
The recording surfaces of double-sided
disc are likeIy
to become dirtied or scratched:
Always make sure
that there is no dirt or scratch on the recording
surface facing the pickup tens, and then use the disc
taking great care that it is not dirtied or scratched.
Use the provided disc cleaning cloth to wipe off any
dirt on disc (see page 26)