Hitachi VM-H71A Instruction Manual page 8

IMPORTANT SAFEGUARDS
receptacles, and the point where they exit from the appliance.
8 Ventilation -- Slots and openings in the cabinet are provided for
ventilation to ensure reliable operation of the video product and to protect
it from overheating. These openings must not be blocked or covered.
The openings should never be blocked by placing the video product on a
bed, sofa, rug or other similar surface. This video product should never be
placed near or over a radiator or heat register. This video product should
not be placed in a built-in installation such as a bookcase or rack unless
proper ventilation is provided or the video product manufacturer's
instructions have been followed.
9 Attachments -- Do not use attachments unless recommended by the
video product manufacturer as they may cause hazards.
Caution: Maintain electrical safety. Power-line operated equipment or
accessories connected to this unit should bear the UL listing mark or CSA
certification mark on the accessory itself and should not have been modified
so as to defeat the safety features. This will help avoid any potential hazard
from electric shock or fire. If in doubt, contact qualified service personnel.
10 Water and Moisture -- Do not use this video product near water -- for
example, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet
basement, or near a swimming pool, and the like.
11 Accessories -- Do not place this video product on an unstable card,
stand, tripod, bracket or table. The video product may fall, causing
serious injury to a child or adult, and serious damage to the appliance.
Use only with a cart, stand, tripod, bracket or table recommended by the
manufacturer, or sold with the video product. Any mounting of the product
should follow the manufacturer's instructions, and should use a mounting
accessory recommended by the manufacturer.
11A An appliance and cart combination should be moved with care.
Quick stops, excessive force, and uneven surfaces may cause the
appliance and cart combination to overturn.
12 Outdoor Antenna Grounding -- If an outside antenna or cable
system is connected to the video product, be sure the antenna or cable
system is grounded so as to provide some protection against voltage
surges and built-up static charges. Section 810 of the National Electrical
Code, ANSI/NFPA No. 70, provides information with respect to proper
grounding of the mast and supporting structure, grounding of the lead-in
wire to an antenna discharge unit, size of grounding conductors, location
of antenna-discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode. See example below:
EXAMPLE OF ANTENNA GROUNDING
13 Power Lines -- An outside antenna system should not be located in
the vicinity of overhead power lines or other electric light or power circuits,
or where it can fall into such power lines or circuits. When installing an
outside antenna system, extreme care should be taken to keep from
touching or approaching such power lines or circuits as contact with them
might be fatal. Installing an outdoor antenna can be hazardous and
should be left to a professional antenna installer.
8