Hitachi VM-E625LA Instruction Manual page 16

Getting Started
you cannot view a picture on the LCD screen.
1. Lift the OPEN lever and pull it up. The power supply attachment cover will open.
2. Lift the battery holder plates at the center of the attachment holder.
3. Insert six alkaline batteries with the correct polarities.
4. After installing the batteries, close the cover. Hold the OPEN lever and align the tabs on both sides of the cover
with the end of the attachment section.
Note: Use only "AA" alkaline batteries marked "LR6". (Manganese batteries cannot be used to power the
camcorder.)
Note: It is recommended that you use alkaline batteries within the recommended period of use or within two
years of the date of manufacture.
Note: Be careful of the following to prevent the leakage of liquid or an explosion.
• Check that the orientation (polarity) of the batteries is correct.
• Remove the batteries when not using the camcorder.
• Remove the used batteries from the camcorder.
• Do not use batteries made by different manufacturers at the same time.
- 16 -