Correcting The Date And Time; Automatic Date Recording; Automatic Title Recording - Hitachi VM-E110A Instruction Manual

Getting Started
Note: The date/time graphics will be recorded whenever they appear in the viewfinder.

Correcting the Date and Time

1. Press the DATE/TITLE button while pressing the stop button. The flashing cursor
appears at the month.
2. Move to where you need to make the correction with the STOP button and use the
F.F and REW to correct.
3. Press the DATE/TITLE button to set the corrected date and time.

Automatic Date Recording

This feature records the date automatically once a day. After you begin recording, the
date is displayed and recorded automatically for 10 seconds. The same date is
recorded again in the following cases; when the cassette is replaced, when " AUTO" is
displayed again after being switched to the date display and when the recording is less
than 10 seconds long.
If the date changes while recording continues over 10 seconds, the date is recorded for
10 seconds when recording is restarted after the camcorder has been set to the standby
once.
Press the DATE/TITLE button until " AUTO" and the date appear at the lower right of
the viewfinder before you begin to record. The date will be recorded whenever it
appears in the viewfinder.

Automatic Title Recording

This function automatically records the created title on the tape together with the date
for about 10 seconds after recording is started.
Note: Be sure to insert the date/title battery before starting automatic title recording.
1. Slide the CAM/OFF/VIDEO switch to CAM.
2. Press the DATE/TITLE button to display " TITLE" in the viewfinder. The created title
and set date will also appear.
3. Press the start/stop button. The title and date are recorded simultaneously on the
tape. 10 seconds after the recording is started, the title and date disappear and the
automatic title recording function is released. (Recording will continue.)
4. To end recording, press the start/stop button again.
31