D-Link NetDefend DFL-210 Cli Reference Manual page 138

Network security firewall
Hide thumbs Also See for NetDefend DFL-210:
Table of Contents

Advertisement

3.30.6. L2TPClient
XAuthPassword
DHCPOverIPsec
AddRouteToRemoteNet
PlaintextMTU
OriginatorIPType
OriginatorIP
OriginatorHAIP
IKEMode
DHGroup
PFS
PFSDHGroup
SetupSAPer
DeadPeerDetection
NATTraversal
KeepAlive
KeepAliveSourceIP
KeepAliveDestinationIP
Metric
AutoInterfaceNetworkRoute
MemberOfRoutingTable
RoutingTable
Comments
XAuth.
Specifies the password to pass to the remote gateway vie IKE
XAuth.
Allow DHCP over IPsec from single-host clients. (Default:
No)
Dynamically add route to the remote networks when a tunnel
is established. (Default: No)
Specifies the size in bytes at which to fragment plaintext
packets (rather than fragmenting IPsec). (Default: 1420)
Specifies what IP address to use as source IP in e.g. NAT.
(Default: LocalInterface)
Manually specified originator IP address to use as source IP
in e.g. NAT.
Manually specified private originator IP address for use in
HA. (Optional)
Specifies which IKE mode to use: main or aggressive.
(Default: Main)
Specifies the Diffie-Hellman group to use when doing key ex-
changes in IKE. (Default: 2)
Specifies whether PFS should be used or not. (Default: None)
Specifies which Diffie-Hellman group to use with PFS.
(Default: 2)
Setup security association per network, host or port. (Default:
Net)
Enable Dead Peer Detection. (Default: Yes)
Enable or disable NAT traversal. (Default: OnIfNeeded)
Disabled, Auto or Manual. (Default: Disabled)
Source IP address used when sending keep-alive ICMP pings.
Destination IP address used when sending keep-alive ICMP
pings.
Specifies the metric for the auto-created route. (Default: 90)
Automatically add a route for this interface using the given
remote network. (Default: Yes)
All or Specific. (Default: All)
Specifies the PBR table to insert the interface IP route into. It
also means that the specified routing table will be used for all
routing lookups, unless overridden by a PBR rule. (Default:
main)
Text describing the current object. (Optional)
138
Chapter 3. Configuration Reference

Advertisement

Table of Contents
loading

Table of Contents