Pcapdump - D-Link NetDefend DFL-210 Cli Reference Manual

2.2.50. pcapdump

-process=<OSPF Router Pro-
cess>
-route
-snoop={ON | OFF}
-verbose
<interface>
<interface>
<lsaID>
<OSPF Area>
<OSPF Neighbor>
{HA | ALT}
2.2.50. pcapdump
Packet capturing.
Description
Packet capture engine
Usage
pcapdump
Show capture status.
pcapdump -start [<interface(s)>] [-size=<value>] [-snaplen=<value>]
Start capture.
pcapdump -stop [<interface(s)>]
Stop capture.
pcapdump -status
Show capture status.
pcapdump -show [<interface(s)>]
Show a captured packets brief.
[-count=<value>] [-out] [-out-nocap]
[-eth=<Ethernet Address>] [-ethsrc=<Ethernet Address>]
[-ethdest=<Ethernet Address>] [-ip=<IP4 Address>]
[-ipsrc=<IP4 Address>] [-ipdest=<IP4 Address>]
[-port=<0...65535>] [-srcport=<0...65535>]
[-destport=<0...65535>] [-proto=<0...255>] [-icmp] [-tcp]
[-udp] [-promisc]
Required if there are >1 OSPF router processes.
Show the internal OSPF process routingtable.
Show troubleshooting messages on the console.
Increase amount of information to display.
OSPF enabled interface.
OSPF enabled interface.
LSA ID.
OSPF Area.
Neighbor.
Show HA routingtable.
58
Chapter 2. Command Reference