Loopbackinterface - D-Link NetDefend DFL-210 Cli Reference Manual

3.30.8. LoopbackInterface

MPPERC456
MPPERC4128
IPPool
DNS1
DNS2
NBNS1
NBNS2
AllowedRoutes
MPPEAllowStateful
MemberOfRoutingTable
RoutingTable
ProxyARPAllInterfaces
ProxyARPInterfaces
Comments
3.30.8. LoopbackInterface
Description
Loopback interfaces will take all packets sent through them and pass them back up a different inter-
face as newly received packets.
Properties
Name
LoopTo
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 56 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
Use an RC4 128 bit MPPE session key with MS-CHAP or MS-
CHAP v2 authentication protocol. (Default: Yes)
A range, group or network that the PPTP/L2TP server will use as
IP address pool to give out IP addresses to the clients from.
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
IP of the primary Windows Internet Name Service (WINS) serv-
er that is used in Microsoft environments which uses the Net-
BIOS Name Servers (NBNS) to assign IP addresses to NetBIOS
names. (Optional)
IP of the primary Windows Internet Name Service (WINS) serv-
er that is used in Microsoft environments which uses the Net-
BIOS Name Servers (NBNS) to assign IP addresses to NetBIOS
names. (Optional)
Restricts networks for which routes may automatically be added.
(Default: all-nets)
Allow usage of Stateful MPPE (less secure, use only for compat-
ibility). (Default: No)
All or Specific. (Default: All)
Specifies the PBR table to insert the interface IP route into. It
also means that the specified routing table will be used for all
routing lookups, unless overridden by a PBR rule. (Default:
main)
Always select all interfaces, including new ones, for publishing
routes via Proxy ARP. (Default: No)
Specifies the interfaces on which the security gateway should
publish routes via Proxy ARP. (Optional)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
Loop back interface. (Optional)
141
Chapter 3. Configuration Reference