Table of Contents
Advertisement
2. Display
2.1.3. Status
Menu Structure - Status
Display Functions
2
[-] Ambient Conditions
[-] Photovoltaic
[-] AC-grid
[-] Grid management
Table 2.3: Status
6
2
Irradiance: 1400W/m
PV module temp: 100
o
C
Ambient temp: 20
o
C
o
Irr. sensor temp: 20
C
[-] Present values
[-] PV input 1
Voltage: 1000V
Current: 15.0 A
Power 10000 W
[+] PV input 2
[+] PV input 3
[-] Isolation Resistance
Resistance: 45 MΩ
[-] PV Input Energy
Total: 369000kWh
PV1: 123000 kWh
PV2: 123000 kWh
PV3: 123000 kWh
[-] PV Configuration
PV input 1: Individual
PV input 2: Individual
PV input 3: Individual
[-] Present Values
[-] Phase 1
Voltage: 250 V
Current: 11.5 A
Frequency: 50 Hz Frequency on phase 1
Power: 4997 W
[+] Phase 2
[+] Phase 3
[-] Residual Current Monitor
Current: 350 mA
[-] Power level adjustment
[-] Present limit: 100 %
[-] Reactive power
Setpoint type: Off
Value: -
8000038784_00_BAL_en / L00410565-01_02
Description
Only applicable if sensors are connected
Irradiance. "NC" if not connected
PV module temperature. "NC" if not connected
Ambient temperature. "NC" if not connected
Irradiation sensor temperature. "NC" if not connected
Voltage detected at PV input 1
Current detected at PV input 1
Power detected at PV input 1
Not visible if inverter type is 10 kW
PV isolation at start up
Daily production of all PV inputs
Daily production of PV input 1
Daily production of PV input 2
Daily production of PV input 3
Configuration of PV input 1. The configuration is only shown when the in-
verter is in Connecting or On grid mode.
Voltage on phase 1
Current on phase 1
Power on phase 1
Residual current in mA
Only visible if the inverter is set up for feed-in to medium or high voltage
grid (e.g. _MV country is the selected country)
Maximum allowed power output in % of nominal power output. "Off"
means that the power level functionality has been disabled in the inverter.
Only displayed if the current country setting is an MV country or custom,
and in Protect PV versions.
The setpoint type for Reactive Power. Off means that no internal setpoints
are used, but the inverter will accept an external setpoint.
The current value of the setpoint for reactive power, the unit depends on
the selected setpoint type.
Hide quick links:
Advertisement
Table of Contents
