Install Trim Kit Frame - Whirlpool MKC2157 Installation Instructions Manual

1. Position trim kit frame over the opening so that the upper tabs
fit inside the rails, as shown.
A
A. Front of trim kit frame
B. Upper tab
C. Rail
D. Lower tab
2. To vertically center the trim kit frame, slide it upward, against
the opening, until the upper tabs catch against the top of the
rails.
3. Holding the trim kit frame firmly in place, use 7/64" drill to drill
four pilot holes into the front facing of the cutout/cabinet
through the mounting hole guides in the upper and lower
corners of the trim kit frame.
NOTES:
To ensure vertical centering, drill the lower holes first.
The holes will be drilled upward from the bottom, and
downward from the top at an angle of about 45°.
A
F
A. Trim kit frame
B. Upper tab
C. Rail
6

Install Trim Kit Frame

B
C
D
B
C
D
E
D. Cutout floor
E. Long wood screw (4 - painted)
F. Mounting hole guide
4. Secure trim kit frame to cutout/cabinet by installing four long
wood screws (painted) into the pilot holes drilled in Step 3
above.
NOTES:
To ensure vertical centering, install the lower screws first.
To avoid damage to the trim kit frame, do not overtighten
screws.
Installation is now complete. Replace any loose items that have
been removed from microwave oven cavity.
Save these Installation Instructions for future reference.