Table of Contents
Advertisement
10. INSTALLATION OF THE DECORATION PANEL
Caution:
With a wireless remote controller, field setting and test operation cannot be performed without attach-
ing the decoration panel.
<If performing a test run without attaching the decoration panel, read "11. FIELD SETTING" and "12. TEST
OPERATION" first.>
Refer to the installation manual attached to the decoration panel.
After installing the decoration panel, ensure that there is no space between the unit body and decoration panel.
Note:
Since the electric insulation sheet sticked to the control box lid gets sandwiched between the unit body and
decoration panel, when closing the lid, slip the insulation sheet between them first and then attach the lid to the
control box.
11. FIELD SETTING
CAUTION
When performing field setting or test operation without attaching the decoration panel, do not
touch the drain pump. This may cause electric shock.
• Check that the outdoor unit has been wired properly.
Make sure the control box lids are closed on the indoor and outdoor units.
Field setting must be made from the remote controller and in accordance with installation conditions.
• Setting can be made by changing the "Mode No.", "FIRST CODE NO." and "SECOND CODE NO.".
• For setting procedures and instructions, see "Field settings" provided with the remote controller.
FIRST CODE NO.
11-1 Setting ceiling height
• Select the SECOND CODE NO. that corresponds to the ceiling height "Table 4".
(SECOND CODE NO. is factory set to "01".)
Table 4
Standard · All
round outlet
Ceiling
height (ft.)
High ceiling 1
High ceiling 2
24
Field settings
Mode
10
0 –
01
4 –––
8 –––
Return
Setting
SECOND CODE NO.
FXFQ - PVJU
09 · 12 · 18
36 · 48 type
· 24 · 30 type
≤ 8-3/4
≤ 10-1/2
8-3/4 - 10
10-1/2 - 12
10 - 11-1/2
12 - 13-3/4
FIELD SET MODE
Mode No.
Mode No.
FIRST
Note) 1
CODE NO.
13 (23)
0
SECOND
CODE NO.
01
02
03
English
Hide quick links:
Advertisement
Table of Contents
