Electrolux EXH09HV1W User Manual page 15

Before you start operating the air conditioner,
set the clock of the remote control using the
procedure given in this section. The clock panel
on the remote control will display the time
regardless of whether the air conditioner is in
operation or not.
After batteries are inserted in the remote control,
1 Control Buttons
Press the Control buttons to set the desired
time.
Forward
Each time you press the buttons the time will
moves forward or backward by 1 minute.
Holding the button down will scroll more rapidly
through the time display.
2 Clock Button
When the desired time is achieved, press the
Clock button again or after 5 seconds with no
clock is set.
3 Re-set the Clock
Press the Clock button and the clock display
Follow step 1 and 2 to set the new time.
tips and information
The clock timer uses a 24 hour clock mode.
The default time for remote control is
12:00PM and it will revert to this when the
batteries are changed.
Backward
Press Eco button in COOL or HEAT (if applicable)
mode, the air conditioner will automatically increase
(in COOL mode) or decrease (in HEAT mode) 1°C per
hour over a 2 hour period. The set temperature will be
steady for the next 5 hours then the unit will stop.
This function permits more comfort and saves energy.
This operation is recommended for bed time.
Set
Set
The remote control works as a remote thermostat,
providing an accurate temperature control and
maximum comfort.
Point the remote control to the indoor unit and press I
that this function is activated.
The I Feel symbol will stay on the display of the
remote control until I Feel button is pressed again.
The air conditioner will operate to reach the set
temperature at the location of the remote control.
The remote control sends the temperature information
at its location to the indoor unit every 10 minutes.
The air conditioner will quit I Feel operation if no
temperature information is received from the remote
control for successive 11 minutes.
Healthy Operation (Models with cold-plasma)
Press the Healthy button to active the Cold Plasma
function. The symbol
remote control until the Healthy button is pressed.
The Cold Plasma generator releases plasma which
can eliminate bacteria, viruses, dusts and other
harmful agents in the air.
This function is recommended when the indoor air
quality is in bad condition.
will stay on the display of the
15